Is it possible to do this in Zbrush ?

Zzam_W · Apr 2014

Hi, it will be really great if somebody could help me on this sclupting issue....

I'm practicing modelling in zbrush, everything looks good, untill this part
seems not symmetry on each other, then I did :

1. duplicate target mesh (part of mesh I want to be symmetry) >
project all > result not so good.

2. merge down layer mesh I created before, and try to join but there is a gap. . .
(is it possible to bridge / close hole ?)

last thing, could somebody tell me which image hoster that friendly
with this forum ?

I want to insert image than using attachment because not directly pointing to my question.

Thanks, hopefuly somebody could help me . . .

[IMG]http://www.polycount.com/forum/<a href=http://postimg.org/image/ilokv9hab/ target=_blank>[/img]

slosh · Apr 2014

You know, you can do a smart resym and it will make your original piece symmetrical. Just mask the side you want to keep. Go under the deformation tab and hit smart resym at the top. This will make the nonsymmetrical side symmetrical.

Zzam_W · Apr 2014

slosh wrote: »

You know, you can do a smart resym and it will make your original piece symmetrical. Just mask the side you want to keep. Go under the deformation tab and hit smart resym at the top. This will make the nonsymmetrical side symmetrical.

Thank you, I stuck with this non-sym problem, I did join the symmetrical side in Max welding each vertex . . . .

Thank you for your solution.

Is it possible to do this in Zbrush ?

Replies