Struggling with Lightmaps

samo8076 · Jul 2014

Hi guys,

I have created a simple wall, un-wrapped the uvs on 2 channels, and repacked with smaller spacing, however I get all sorts of bleeds all over the mesh. I have followed various tutorials, and read the official documentation, but I cannot figure it out.

I have attached a screenshot and my 3ds max project for reference. 3ds max project available from here

Any ideas?

Thanks

electricsauce · Jul 2014

What's your texture resolution? How much space is between your uvs?

samo8076 · Jul 2014

Hi, thanks for the reply. I managed to sort it last night. It was a combination of lightmap uv's with not enough spacing (hence the bleed), and a the lightmap res being low.

Struggling with Lightmaps

Replies