Makarov Material Practice, CRITICS PLEASE!

maxivz · Feb 2014

I am not very good when it comes to texturing, so i decided to come once again to you for help! :poly142:
Please hit it as hard as you can! :thumbup:

makarov%20%281%29.png

DWalker · Feb 2014

The brass on the shell casings feels more like plastic than metal. What colors are you using for the specular? Adding a reflection to the brass also really helps, assuming you're going for a render rather than real-time.

Also, Russian rounds often used a steel rather than a brass case, with a distinct red stripe at the bullet/case boundary.

maxivz · Feb 2014

The bullet was based in a standard 9mm bullet i googled for so thats why it has brass on it, it also gives it the more typical bullet look, for my brass material i am using a dark green diffuse, bright yellow specular and a very bright gloss, i am also struggling with the cooper.
I am going for real time art

zanzindorf · Feb 2014

It looks really sweet! I also think the bullets look a bit off. It feels like the color is too vibrant. Maybe you could try desaturating the color a bit.

The scratches and scuff marks are spot on though.

maxivz · Feb 2014

I still feel like its missing low level details, as i always tend to overdo them and it always ends up looking nosiy, i worked on the bullets, i hope this is better. Please keep em coming!

woot · Feb 2014

id add some more wear where the safety switch is, check these references for some more ideas:

http://imgur.com/a/ndar0

Shrike · Feb 2014

Set up more lights before you adjust too much to the current situation, its clearly way too dark and you cannot texture properly under those conditions

maxivz · Feb 2014

What about this light setup? I also worked a bit more on the materials, but i am afraid that they became too noisy screenshot001%20%282%29.png

SuperDuty455 · Feb 2014

Seems like you used the same bakelite texture for the grip, the hammer and the safety, but only the grip is made of bakelite.

It's quite unlikely those two vital components would be made of some kind of plastic ^^

maxivz · Feb 2014

SuperDuty455 wrote: »

Seems like you used the same bakelite texture for the grip, the hammer and the safety, but only the grip is made of bakelite.

It's quite unlikely those two vital components would be made of some kind of plastic ^^

I dont know if its fake, but i have seen several makarovs with that setup

Maybe its just the outside covered with bakelite or something

KnechtRuprecht · Feb 2014

It has indeed the same color, but the hammer and the safety are made out of metal. Bakelite would break, its very brittle. I dont know what metal though, any gun nut here maybe?

Makarov Material Practice, CRITICS PLEASE!

Replies